Loopback interface – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 73
Table 11. Slot configuration information (stacked switch configuration) (Continued)
Description
Field
Indicates if the power state can be administratively enabled or disabled.
This field is always False.
Card Power Down
Indicates if the switch is pluggable. This field is always False.
Card Pluggable
The following table describe the view-only fields in the Supported Card table on the
page.
Table 12. Supported card information (information about supported M4350 series switches for a stack)
Description
Field
The model ID of the supported switch
Card Model
The index assigned to the supported switch
Card Index
The hardware type of the supported switch, which is assigned by the
manufacturer
Card Type
The description of the supported switch
Card Descriptor
The following table describe the view-only fields in the Supported Switch table on the
page. If you preconfigure a new stack member, the switch index identifies the type of
switch that is being added to the stack.
Table 13. Supported switch information (switch index and management preference information)
Description
Field
The model number of the supported switch
Switch Model ID
The index that is assigned to the supported switch
Switch Index
The management preference of the supported switch
Management Preference
Loopback interface
A loopback interface lets you send a ping, traceroute, and other test traffic as well as
protocol traffic to the switch. A loopback interfaces requires a unique IPv4 or IPv6
network address. You can add one or more loopback interfaces.
To add a loopback interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
Main User Manual
73
Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual