NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 91
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > Management > Management Interfaces > IPv6 Management
Interface Configuration.
The IPv6 Management Interface Configuration page displays.
6. To add an IPv6 address, in the IPv6 Management Interface Configuration section,
do the following:
a. Select the Set Management Interface check box.
It is likely that you already did this when you started the configuration of the IPv6
management interface.
b. In the IPv6 Prefix field, specify the IPv6 address that you want to add.
c. In the Prefix Length field, specify the prefix length for the IPv6 address that you
want to add.
d. From the EUI64 menu, select Enable to enable the Extended Universal Identifier
(EUI) flag for the IPv6 address, or select Disable to omit the flag.
e. Click the Add button.
The IPv6 address is added to the IPv6 management interface.
7. To remove an IPv6 address, in the IPv6 Management Interface Configuration section,
do the following:
a. Select the check box for the IPv6 that you want to remove.
b. Click the Delete button.
The IPv6 address is removed from the IPv6 management interface.
8. To save the settings to the running configuration, click the Save icon.
Manage the IPv6 default route addresses
for the IPv6 management interface
You can add an IPv6 default route address that is specific to the IPv6 management
interface. You can also remove an IPv6 default route address that you no longer need
for the IPv6 management interface.
Main User Manual
91
Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual