NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 116)

5. Select System > Management > Green Ethernet > Green Ethernet Interface
Configuration.
The Green Ethernet Interface Configuration page displays.
6. If a stack is configured, select whether to display the physical interfaces for one switch
or for all switches in the stack:
• Unit ID for a stacked switch: The physical interfaces for the switch with the
selected stack unit ID are displayed.
If no switch stack is configured, the only option is unit ID 1.
• All: The physical interfaces for all switches in the stack are displayed.
If no switch stack is configured, the All option does not have any effect.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
8. From the Auto Power Down mode menu, select Enable or Disable.
By default, this mode is disabled for the interface. When a port link is down, the
underlying physical layer goes down for a short period and then checks for port link
pulses again so that auto-negotiation remains possible. In this way, the switch saves
power when no link partner is present for the port. If the Auto Power Down mode is
not supported for the interface, N/A is displayed.
9. From the EEE mode menu, select Enable or Disable.
By default, this mode is disabled for an interface. Energy Efficient Ethernet (EEE)
combines the MAC with a family of physical layers that support operation in a low
power mode. It is defined by the IEEE 802.3az standard. Lower power mode enables
both the send and receive sides of the link to disable some functionality for power
savings when lightly loaded. Transition to low power mode does not change the link
status. Frames in transit are not dropped or corrupted in transition to and from a
port in low power mode. Transition time is transparent to upper layer protocols and
applications.
10. Click the Apply button.
Your settings are saved.
11. To save the settings to the running configuration, click the Save icon.
Main User Manual 116 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual