NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 266)

If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > Auto-VLAN > Auto-Camera > Global Configuration.
The Auto-Camera Global Configuration page displays.
6. Select the Admin Mode Disable or Enable radio button.
This specifies whether the Auto-Camera capability is enabled on the switch. By
default, the Auto-Camera capability is disabled.
7. In the VLAN ID field, type the ID of the VLAN that must function as the Auto-Camera
VLAN.
8. From the Priority menu, select the priority for traffic on the Auto-Camera VLAN.
You can select a value from 0 to 7. The default value is 7.
9. Click the Apply button.
Your settings are saved.
The page displays the number of devices (camera channels) that are active on the
Auto-Camera VLAN.
Configure an interface as member of the
Auto-Camera VLAN
You can configure an interface as member of the Auto-Camera VLAN.
To configure an interface as member of the Auto-Camera VLAN:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
Main User Manual 266 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual