beautypg.com

Storm control, Configure global storm control settings – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 735

background image

You can specify a single VLAN ID, a range of VLAN IDs, or a combination of both in
sequence separated by a comma (,):

You can specify individual VLAN ID, such as 10.

You can specify the VLAN range values separated by a hyphen, for example,
10-13.

You can specify the combination of both separated by commas, for example:
12,15,40–43,1000–1005, 2000.

NOTE: The VLAN IDs that you specify overwrites the secondary VLANs that
you configured on the Private VLAN Association Configuration page (see
Configure a private VLAN association with a primary and secondary VLAN
on page 718).

10. Click the Apply button.

Your settings are saved.

The Operational VLAN(s) field shows the VLANs that operate on the private VLAN
trunk interface.

11. To save the settings to the running configuration, click the Save icon.

Storm control

A broadcast storm is the result of an excessive number of broadcast messages
simultaneously transmitted across a network by a single port. Forwarded message
responses can overload network resources, cause the network to time out, or do both.

The switch measures the incoming packet rate per port for broadcast, multicast, unknown,
and unicast packets and discards packets if the rate exceeds the defined value. You
enable storm control per interface, by defining the packet type and the rate at which
the packets are transmitted.

Configure global storm control settings

The global storm control settings apply to all ports. After you configure the global
settings, you can specify storm control settings for one or more ports.

To configure global storm control settings:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

Main User Manual

735

Manage Switch Security

Fully Managed Switches M4350 Series Main User Manual