NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 257)

The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > VLAN > Advanced > GARP Port Configuration.
The GARP Port Configuration page display.
6. Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
• 1 or Unit ID for a stacked switch:
- 1: If no switch stack is configured, the physical interfaces for the switch are
displayed.
- Unit ID for a stacked switch: If a switch stack is configured, the physical
interfaces for the switch with the selected stack unit ID are displayed.
• LAG: Only LAGs are displayed.
• All: Both physical interfaces and LAGs are displayed, or for a switch stack, both
physical interfaces on all switches in the stack and LAGs are displayed.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
8. From the GVRP Mode menu, select Enable or Disable to specify the GARP VLAN
registration protocol mode for the port.
If you select Disable, GVRP is not active and the join time, leave time, and leave all
time options are without any effect. The default is Disable.
9. From the GMRP Mode menu, select Enable or Disable to specify the GARP multicast
registration protocol mode for the port.
If you select Disable, GMRP is not active and the join time, leave time, and leave all
time options are without any effect. The default is Disable.
10. In the Join Timer field, specify the time in centiseconds between the transmission
of GARP PDUs registering membership for a VLAN or multicast group.
Main User Manual 257 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual