Configure an ospf interface – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 470
•
Enable: The address range is advertised outside the area through Network
Summary LSAs. This is the default setting.
•
Disable: The address range is not advertised outside the area.
11. Click the Add button.
The OSPF ID and area range are added.
12. To save the settings to the running configuration, click the Save icon.
Configure an OSPF interface
You can configure one or more OSPF interfaces, which are interfaces that are connected
to OSPF areas over point-to-point or broadcast connections.
To configure an OSPF interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > OSPF > Advanced > Interface Configuration.
The OSPF Interface Configuration page displays.
6. Select whether to display physical interfaces, VLANs, or both by clicking one of the
following links above the table heading:
•
1 or Unit ID for a stacked switch:
Main User Manual
470
Configure OSPF and OSPFv3
Fully Managed Switches M4350 Series Main User Manual