NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 189)

5. Select System > SNMP > SNMP V1/V2 > Community Configuration.
The Community Configuration page displays.
6. Select the check box next to the community.
7. Change the settings as needed.
For more information about the settings, see Add an SNMPv1 and SNMPv2
community on page 187.
8. Click the Apply button.
Your settings are saved.
9. To save the settings to the running configuration, click the Save icon.
Delete an SNMPv1 and SNMPv2 community
You can delete an SNMPv1 and SNMPv2 community that you no longer need.
To delete an SNMPv1 and SNMPv2 community:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > SNMP > SNMP V1/V2 > Community Configuration.
The Community Configuration page displays.
6. Select the check box next to the community.
7. Click the Delete button.
The community is deleted.
8. To save the settings to the running configuration, click the Save icon.
Main User Manual 189 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual