NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 824)

The page that displays lets you configure the IPv6 rule.
8. Configure the following options for the rule:
• Sequence Number: Enter a whole number in the range of 1 to 2147483647.
This number is used to identify the rule. An IPv6 ACL can contain up to 1023
rules.
• Action: Select the ACL forwarding action by selecting one of the following radio
buttons:
- Permit: Forward packets that meet the ACL criteria.
- Deny: Drop packets that meet the ACL criteria.
• Egress Queue: If you select the Permit radio button, select the hardware egress
queue identifier that is used to handle all packets matching this IPv6 ACL rule.
The range of queue IDs is from 0 to 6.
• Logging: If you select the Deny radio button, you can enable logging for the
ACL by selecting the Enable radio button. (Logging is subject to resource
availability in the device.)
If the access list trap flag is also enabled, periodic traps are generated, indicating
the number of times this rule was evoked during the report interval. A fixed
five-minute report interval is used for the switch. A trap is not issued if the ACL
rule hit count is zero for the current interval.
• Interface: If you select the Permit radio button, use either a mirror interface or
a redirect interface:
- Select the Mirror Interface radio button and use the menu to specify the
egress interface to which the matching traffic stream is copied, in addition to
being forwarded normally by the device.
- Select the Redirect Interface radio button and use the menu to specify the
egress interface to which the matching traffic stream is forced, bypassing any
forwarding decision normally performed by the device.
• Match Every: Select whether all packet must match the selected IPv6 ACL rule:
- Disable: Not all packets need to match the selected IPv6 ACL rule. You can
configure other match criteria on the page.
- Enable: All packets must match the selected IPv6 ACL rule and are either
permitted or denied. In this case, you cannot configure other match criteria
on the page.
• Protocol Type: Specify the IPv6 protocol type in one of the following ways:
- From the Protocol Type menu, select IPv6, ICMPv6, TCP, or UDP.
- From the Protocol Type menu, select Other, and in the associated field,
specify an integer ranging from 0 to 255. This number represents the IPv6
protocol.
Main User Manual 824 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual