NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 51)

To display information about the stack configuration:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > Stacking > Basic > Stack Configuration.
The Stack Configuration page displays. The page shows different sections.
6. Go to the Basic Stack Status section.
The following table describes the view-only fields in the section:
Description Field
The unit ID of the switch in the stack Unit ID
The description for the switch, which effectively is the switch model number Switch Description
The serial number of the switch Serial Number
The period since the switch was restarted Uptime
The model type assigned by the switch manufacturer, which effectively is the switch
model number Preconfigured Model
Identifier
The model type assigned by the switch manufacturer to identify the plugged-in switch.
(The Plugged-In Model Identifier can be the same as the Preconfigured Model
Identifier.) Plugged-In Model
Identifier
The detected version of the firmware of the switch Detected Code
Version
The detected version of the firmware of the switch in flash memory Detected Code in
Flash
The status of the most recent stack firmware synchronization (SFS). SFS Last Attempt
Status
Main User Manual 51 Manage Stacking
Fully Managed Switches M4350 Series Main User Manual