beautypg.com

Basic ip acl sample configuration – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 914

background image

You can assign an optional sequence number to indicate the order of this access list
relative to other access lists if any are already assigned to this interface and direction.

4. The MAC Binding Table displays the interface and MAC ACL binding information.

(See Display or delete MAC ACL bindings in the MAC binding table on page 803.)

The ACL named Sales_ACL looks for Ethernet frames with destination and source MAC
addresses and MAC masks defined in the rule. Also, the frame must be tagged with
VLAN ID 2, which is the Sales department VLAN. The CoS value of the frame must be
0, which is the default value for Ethernet frames. Frames that match this criteria are
permitted on interfaces 6, 7, and 8 and are assigned to the hardware egress queue 0,
which is the default queue. All other traffic is explicitly denied on these interfaces. To
allow additional traffic to enter these ports, you must add a new Permit rule with the
desired match criteria and bind the rule to interfaces 6, 7, and 8.

Basic IP ACL sample configuration

The following example shows how to create an IP-based ACL that prevents any IP traffic
from the Finance department from being allowed on the ports that are associated with
other departments. Traffic from the Finance department is identified by each packet’s
network IP address.

1. On the IP ACL page, create a new IP ACL with an IP ACL ID of 1. (See Configure a

basic or extended IPv4 ACL on page 804.)

2. On the IP Rules page, create a rule for IP ACL 1 with the following settings:

Sequence Number: 1

Action: Deny

Assign Queue ID: 0 (optional: 0 is the default value)

Match Every: False

Source IP Address: 192.168.187.0

Source IP Mask: 255.255.0

For additional information about IP ACL rules, see Configure rules for a basic IP ACL
on page 808.

3. Click the Add button.

4. On the IP Rules page, create a second rule for IP ACL 1 with the following settings:

Sequence Number: 2

Action: Permit

Match Every: True

5. Click the Add button.

Main User Manual

914

Configuration Examples

Fully Managed Switches M4350 Series Main User Manual