NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 859)

Event log
You can display and clear the event log, which contains error messages from the switch.
NOTE: If you reset the switch to factory default settings, the event log is not
cleared.
To display or clear the event log:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Monitoring > Logs > Event Logs.
The Event Logs page displays.
6. To refresh the page, click the Refresh button
7. To clear the log, click the Clear button.
8. To save the settings to the running configuration, click the Save icon.
The following table describes the event log information displayed on the page.
Table 187. Event logs information
Description Field
The sequence number of the event. Entry
The type of the event. Type
The file in which the event originated. File Name
The line number of the event. Line
The task ID of the event. Task ID
Main User Manual 859 Monitor the Switch and Network
Fully Managed Switches M4350 Series Main User Manual