Configure an mvr group – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 340
Table 82. MVR configuration information
Definition
Field
The maximum number of multicast groups that MVR supports.
MVR Max Multicast Groups
The number of the MVR groups allocated.
MVR Current Multicast Groups
Configure an MVR group
You can configure an MVR group. After you configure interfaces for MVR, you can add
them as members to the MVR group.
To configure an MVR group:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > MVR > Advanced > MVR Group Configuration.
The MVR Group Configuration page displays.
6. In the MVR Group IP field, specify the IP address for the new MVR group.
7. In the Count field, specify the number of contiguous MVR groups.
This number helps you to create multiple MVR groups through a single click of the
Add button. If the field is empty, then clicking the button creates only one new group.
The field is displayed as empty for each particular group. The range is from 1 to 256.
8. Click the Add button.
The MVR group is added.
9. To save the settings to the running configuration, click the Save icon.
The following table describes the view-only fields on the page.
Main User Manual
340
Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual