NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 897)

6. Select the check box for the image that is not the active image (that is, the image for
which the Active Image fields shows False) but that you want the switch to run after
it reboots.
If you configured a switch stack, you can select the image that loads for each switch
in the stack.
7. From the Next Active Image menu, select True.
8. As an option, specify a name for the selected image by entering one in the Image
Description field.
9. Click the Apply button.
Your settings are saved.
10. To save the settings to the running configuration, click the Save icon.
11. After activating the image, reboot the switch (see Reboot the switch from the main
UI on page 879).
If you do not reboot the switch, it continues running the image shown in the
Current-active field until the next time that the switch reboots.
The following table describes the view-only fields on the page.
Table 189. Dual image configuration information
Description Field
The switch stack unit ID. If you did not configure a stack, the unit ID is 1. Unit
The name of the image. By default, the image names are image1 and image2. Image Name
The current active image (True or False). Active Image
The firmware version of the image. Version
Delete a software image
You can delete a software image that is not the active image. If you configured a switch
stack, you can delete the image that is not the active image for one or more switches
in the stack.
To delete a software image:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
Main User Manual 897 Maintenance and
Troubleshooting
Fully Managed Switches M4350 Series Main User Manual