Send an ipv4 traceroute – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 902
The valid range is from 0 to 13000. The default value is 0 bytes.
11. From the Source menu, as an option, you can select the IP address or interface that
must be used to send echo request packets:
•
None: The source address of the ping packet is the address of the default egress
interface.
•
IPv6 Address: The source IP address that must be used when echo request
packets are sent. With this selection, the IPv6 Address field displays and you
must enter the IPv6 address that must be used as the source.
•
Interface: The interface that must be used when echo request packets are sent.
The Interface menu displays, and you must select the interface.
12. Click the Apply button.
The specified address is pinged. The results are displayed below the configurable
data in the Results field.
Send an IPv4 traceroute
You can configure the switch to send a traceroute request to a specified IPv4 address
or host name. You can use this to discover the paths that packets take to a remote
destination. When you send a traceroute, the switch displays the results below the
configurable data.
If a reply to the traceroute is received, the following message displays:
traceroute to x.y.z.w (x.y.z.w), maxTTL hops max, size byte packets
initTTL x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
initTTL+1 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
initTTL+2 x.y.z.w (x.y.z.w) 0.000 ms * 0.000 ms
To send an IPv4 traceroute:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
Main User Manual
902
Maintenance and
Troubleshooting
Fully Managed Switches M4350 Series Main User Manual