NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 851)

Messages logged to a collector or relay through syslog use a format identical to the
previous message.
• Total number of Messages: For the message log, only the latest 200 entries are
displayed on the page.
Enable or disable the command
configuration log
The switch can log changes that are made with CLI configuration commands.
To enable or disable the command configuration log:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Monitoring > Logs > Command Log Configuration.
The Command Log Configuration page displays.
6. Select one of the following Admin Status radio buttons:
• Enable: Enable the switch to log CLI configuration commands. This is the default
setting.
• Disable: Prevent the switch from logging CLI configuration commands.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
Main User Manual 851 Monitor the Switch and Network
Fully Managed Switches M4350 Series Main User Manual