NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 326)

6. Select the MLD Snooping Admin Mode Enable or Disable radio button to specify
the administrative mode for MLD snooping for the switch. The default is Disable.
7. Select the Proxy Querier Mode Enable or Disable radio button.
This enables or disables an MLD proxy querier on the system. If it is disabled, then
an MLD proxy query with source IP 0::0 is not sent in response to an MLD leave
packet. If it is enabled, then MLD proxy queries are sent. The default is Enable.
8. Select the Exclude Mrouter Interface Mode Enable or Disable radio button.
This selection specifies the type of information that is forwarded to the upstream
multicast router interface.
If enabled, the switch blocks all unknown multicast data through the mrouter port,
whether the port is configured dynamically or statically. Only MLD PDUs are allowed
to pass through the mrouter port to the upstream router interface.
The default is Enable. If disabled, the switch forwards both unknown multicast data
and MLD PDUs to the upstream multicast router interface.
NOTE: For information about MLD Plus mode, see Configure MLD snooping
automatically with MLD Plus mode on page 324.
9. Click the Apply button.
Your settings are saved.
10. To save the settings to the running configuration, click the Save icon.
11. To refresh the page, click the Refresh button.
The following table describes the view-only fields on the page.
Table 80. MLD snooping configuration information
Definition Field
The number of multicast control frames that were processed. Multicast Control Frame Count
The interface on which MLD snooping is administratively enabled. MLD
snooping must be enabled globally and on an interface for the interface
to be able to snoop MLD packets to determine which segments should
receive multicast packets directed to the group address. Interfaces Enabled for MLD
Snooping
The VLAN on which MLD snooping is administratively enabled. VLAN IDs Enabled For MLD
Snooping
Configure the MLD snooping settings for
interfaces
You can configure the MLD snooping settings for interfaces.
Main User Manual 326 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual