NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 919)

For more information about this page, see Configure a DiffServ class on page 599.
2. Click the Class1 hyperlink to display the DiffServ Class Configuration page for this
class.
3. Configure the following settings for Class1:
• Protocol Type: UDP
• Source IP Address: 192.12.1.0.
• Source Mask: 255.255.255.0.
• Source L4 Port: Other, and enter 4567 as the source port value.
• Destination IP Address: 192.12.2.0.
• Destination Mask: 255.255.255.0.
• Destination L4 Port: Other, and enter 4568 as the destination port value.
For more information about this page, see Configure a DiffServ class on page 599.
4. Click the Apply button.
5. On the Policy Configuration page, create a new policy with the following settings:
• Policy Selector: Policy1
• Member Class: Class1
For more information about this page, see Configure a DiffServ policy on page 612.
6. Click the Add button.
The policy is added.
7. Click the Policy1 hyperlink to display the Policy Class Configuration page for this
policy.
8. Configure the Policy attributes as follows:
• Assign Queue: 3
• Policy Attribute: Simple Policy
• Color Mode: Color Blind
• Committed Rate: 1000000 Kbps
• Committed Burst Size: 128 KB
• Confirm Action: Send
• Violate Action: Drop
For more information about this page, see Configure a DiffServ policy on page 612.
9. On the Service Configuration page, select the check box next to interfaces 7 and 8
to attach the policy to these interfaces, and then click the Apply button. (See
Configure the DiffServ service interface on page 620.)
Main User Manual 919 Configuration Examples
Fully Managed Switches M4350 Series Main User Manual