NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 76)

The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > Management > Management Interfaces > IPv4 Service Port
Configuration.
The IPv4 Service Port Configuration page displays.
6. Select a Service Port Configuration Protocol radio button:
• Bootp: During the next boot cycle, the BootP client on the device broadcasts a
BootP request to acquire information from a BootP server on the network.
The IP Address, Subnet Mask, and Default Gateway field information is dynamically
acquired.
• DHCP: During the next boot cycle, the DHCP client on the device broadcasts a
DHCP request to acquire information from a DHCP server on the network.
The IP Address, Subnet Mask, and Default Gateway field information is dynamically
acquired.
• None: The device does not attempt to acquire network information dynamically.
You must configure the address settings manually:
- IP Address: Specify the IP address of the interface.
- Subnet Mask: Specify the IP subnet mask for the interface.
- Default Gateway: Specify the default gateway for the IP interface.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
The following table describes the view-only fields on the page.
Table 14. IPv4 service port configuration information
Description Field
The burned-in MAC address used for out-of-band connectivity. Burned-in MAC Address
Indicates whether the link status is up or down. Interface Status
If the selection is DHCP, the DHCP client ID. DHCP Client Identifier
Main User Manual 76 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual