NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 428)

• T (tagged) member: The LAG is added as a tagged member of the VLAN.
• U (untagged) member: The LAG is added as an untagged member of the VLAN.
• Excluded member: By default, the selection is blank, which means that the LAG
is excluded from the VLAN. A LAG that is excluded can still be dynamically added
to the VLAN through GVRP.
11. Click the Apply button.
Your settings are saved.
12. To save the settings to the running configuration, click the Save icon.
Configure routing for an existing VLAN
For an existing VLAN, you can add or change an IPv4 address and subnet mask and
configure routing for the VLAN.
To add or change routing for an existing VLAN:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > VLAN > VLAN Routing Configuration.
The VLAN Routing page displays.
6. If you are changing an existing routing VLAN, select the check box for the VLAN.
7. If you are adding a new routing VLAN, from the VLAN ID menu, select the VLAN ID.
This menu displays the IDs of all VLANs that are configured on this switch.
8. In the IP Address field, specify the IP address for the routing VLAN.
9. In the Subnet Mask field, specify the subnet mask for the routing VLAN.
10. Do one of the following:
Main User Manual 428 Manage Routing
Fully Managed Switches M4350 Series Main User Manual