Map dscp values to queues – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 589
Map DSCP values to queues
You can map an internal traffic class to a DSCP value.
To map DSCP values to queues:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select QoS > CoS > Advanced > IP DSCP Queue Mapping.
The IP DSCP Queue Mapping page displays.
The IP DSCP field displays an IP DSCP value from 0 to 63.
6. For each DSCP value, specify which internal traffic class to map the corresponding
queue.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
Configure the CoS interface settings for an
interface
You can configure the trust mode for one or more interfaces and apply an interface
shaping rate to all interfaces or to a specific interface.
To configure CoS settings for an interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
Main User Manual
589
Configure Quality of Service
Fully Managed Switches M4350 Series Main User Manual