Manage ipv6 addresses for the ipv6 management vlan – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 86

Table 17. Current IPv6 management interface status information

Description

Field

The IPv6 management interface. (By default, no IPv6 management
interface is configured).

Management Interface

Indicates if the link status is up or down.

Link State

Indicates if the link status is up or down for the IPv6 management interface.

IPv6 Routing Interface
Status/Operational Mode

The MAC address that is assigned to the IPv6 management interface.

MAC Address

Indicates if IPv6 is enabled or disabled on the IPv6 management interface.

IPv6 Enable Mode

Indicates if IPv6 routing is enabled or disabled on the IPv6 management
interface.

IPv6 Routing Mode

Indicates if the DHCPv6 Client Mode is enabled or disabled on the IPv6
management interface.

DHCPv6 Client Mode

The IPv6 address of the default gateway of the switch.

IPv6 Default Gateway

The IPv6 address of the next hop interface of the switch.

IPv6 Next Hop Interface

The IPv6 prefix and prefix length that is used for the IPv6 management
interface.

IPv6 Prefix/Prefix Length

The EUI-64 flag of the IPv6 address on the IPv6 management interface.

EU164

The current state of the IPv6 address on the IPv6 management interface.

Current State

Manage IPv6 addresses for the IPv6
management VLAN

You can add a static IPv6 address that is specific to the IPv6 management VLAN. You
can also remove an IPv6 address that you no longer need for the IPv6 management
VLAN.

To add or remove an IPv6 address for the IPv6 management VLAN:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.