Display or clear mld traffic statistics – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 576
Table 141. MLD groups information (Continued)
Description
Field
The compatibility mode (MLDv1 or MLDv2) of the multicast group on the
interface.
Group Compat Mode
The source addresses that are members of the multicast address.
Source Hosts
The expiration time after which each source address that is a member of
the multicast group ages out.
Source Address (Expiry Time)
Display or clear MLD traffic statistics
You can view the MLD traffic statistics and clear these statistics.
To view or clear IPv6 MLD traffic statistics:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > IPv6 Multicast > MLD > MLD Traffic.
The MLD Traffic page displays.
6. To refresh the page, click the Refresh button.
7. To reset (clear) all MLD traffic statics, click the Clear button.
8. To save the settings to the running configuration, click the Save icon.
The following table describes the view-only fields on the page.
Main User Manual
576
Configure Multicast Routing
Fully Managed Switches M4350 Series Main User Manual