NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 319)

Configure the IGMP snooping querier global
settings
You can configure the global settings for an IGMP snooping querier on the switch.
To configure the global settings for an IGMP snooping querier:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > Multicast > IGMP Snooping > Querier Configuration.
The Querier Configuration page displays.
6. Select the Querier Admin Mode Enable or Disable radio button to specify if IGMP
snooping is enabled for the switch.
The default is Disable.
7. In the Snooping Querier IP Address field, specify the snooping querier IP address
that must be used as the source address in periodic IGMP queries.
This address is used when no address is configured on the VLAN on which queries
are sent.
8. In the IGMP Version field, specify the IGMP protocol version used in periodic IGMP
queries.
The version can be 1 to 2. The default is 2.
9. In the Query Interval (secs) field, specify the period in seconds between periodic
queries sent by the snooping querier.
The range is from 1 to 1800 seconds. The default is 60 seconds.
10. In the Querier Expiry Interval (secs) field, specify the period in seconds after which
the last querier information is removed.
The range is from 60 to 300 seconds. The default is 180 seconds.
Main User Manual 319 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual