beautypg.com

Configure an mld snooping querier for a vlan – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 335

background image

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Switching > Multicast > MLD Snooping > Querier Configuration.

The Querier Configuration page displays.

6. Select the Querier Admin Mode Enable or Disable radio button to specify if MLD

snooping is enabled for the switch.

The default is Disable.

7. In the Querier Address field, specify the snooping querier IP address that must be

used as the source address in periodic MLD queries.

This address is used when no address is configured on the VLAN on which queries
are sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x.

NOTE: The MLD Version field always states MLD protocol version 1. This
is the version that is used in periodic MLD queries.

8. In the Query Interval (secs) field, specify the period in seconds between periodic

queries sent by the snooping querier.

The range is from 1 to 1800 seconds. The default is 60 seconds.

9. In the Querier Expiry Interval (secs) field, specify the period in seconds after which

the last querier information is removed.

The range is from 60 to 300 seconds. The default is 60 seconds.

10. Click the Apply button.

Your settings are saved.

The page displays the VLAN IDs enabled for MLD snooping querier.

11. To save the settings to the running configuration, click the Save icon.

Configure an MLD snooping querier for a
VLAN

You can configure an MLD querier for use with a VLAN on the network.

Main User Manual

335

Configure Switching Information

Fully Managed Switches M4350 Series Main User Manual