Configure usb logging – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 860
Table 187. Event logs information (Continued)
Description
Field
The event code.
Code
The time this event occurred.
Time
Configure USB logging
If you connect a USB storage device such as a flash drive to the switch, the switch logs
messages to the device.
To configure USB logging:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Monitoring > Logs > USB Log Configuration.
The USB Log Configuration page displays.
6. From the USB Log Mode menu, select how logging occurs:
•
Overwrite on full: The switch logs messages to the USB device and overwrites
old messages if the USB is full. This is the default setting.
•
Stop on Full: The switch logs messages to the USB device and stops logging if
the USB device is full.
•
Disable: Prevent the switch from logging messages to the USB device.
7. From the USB Log Mode menu, select the logging level for messages that must be
logged.
Main User Manual
860
Monitor the Switch and Network
Fully Managed Switches M4350 Series Main User Manual