NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 586)

whole, based on the existing port default priority as mapped to a traffic class by the
current 802.1p mapping table.
Alternatively, when a port is configured as untrusted, it does not trust any incoming
packet priority designation and uses the port default priority value instead. All packets
arriving at the ingress of an untrusted port are directed to a specific CoS queue on the
appropriate egress ports, in accordance with the configured default priority of the
ingress port. This process is also used for cases where a trusted port mapping cannot
be honored, such as when a non-IP packet arrives at a port configured to trust the IP
DSCP value.
Configure the CoS trust mode settings
globally or for a specific interface
A global CoS trust mode configuration setting is applied to all interfaces on the switch.
A CoS trust mode configuration setting for an interface is applied to the selected interface
only. To configure the CoS trust mode for more than one interface, repeat the task for
each selected interface.
To configure the CoS trust mode settings on all interfaces or on a specific interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select QoS > CoS > Basic > CoS Configuration.
The CoS Configuration page displays.
6. Either configure the same CoS trust mode settings for all CoS-configurable interfaces
or configure CoS settings per interface.
By default, the Global radio button is selected.
Main User Manual 586 Configure Quality of Service
Fully Managed Switches M4350 Series Main User Manual