NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 3
Contents
Chapter 1 Get Started with the Main UI
Available publications and online help......................................... 25
Supported switches.......................................................................... 25
Register your product...................................................................... 26
Main local browser UI overview...................................................... 26
Log in to the main UI with a web browser..................................... 27
Log in to the main UI using the switch default IP address...... 28
Log in to the main UI with a known IP address......................... 28
Main UI buttons and user-defined fields................................... 29
Interface naming conventions.................................................... 30
Save your settings to the running configuration...................... 30
Main UI online help...................................................................... 31
Use the Device View in the Main UI................................................ 31
Set up SNMPv3 access..................................................................... 33
Switch stacking overview................................................................. 36
Stack firmware synchronization and upgrade............................... 37
Stack configuration maintenance................................................... 37
Stack management switch election................................................ 38
Stack factory defaults reset behavior............................................. 38
Stacking limitations........................................................................... 39
Configure a stack.............................................................................. 39
Set the stack sample mode......................................................... 40
Add a switch as the stack management switch........................ 41
Add a stack member or standby management switch............ 42
Change the setting for a switch in the stack............................. 44
Remove a switch from the stack................................................. 46
Configure the stack mode for a port......................................... 46
Configure stack firmware synchronization................................ 48
Configure the trunk hash mode................................................. 49
Display information about the stack configuration.................. 50
Display the heartbeat message stack status............................. 52
Display stack port diagnostic, status, and path information.... 53
Remove a stack............................................................................. 54
Stack nonstop forwarding............................................................... 55
3