beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 259

background image

Session Initiation Protocol (SIP)

H.323

Signalling Connection Control Part (SCCP)

VoIP packets that come in on an interface on which Auto-VoIP is enabled are marked
with the specified CoS traffic class value.

To configure protocol-based settings for one or more interfaces:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Log in to the main UI with a web
browser
on page 27 and the subsections.

The login page displays.

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Switching > Auto-VoIP > Protocol-based > Port Settings.

The Port Settings page displays.

6. In the Protocol Based Global Settings section, specify the following global settings:

a. From the Prioritization Type menu, select Traffic Class or Remark.

This specifies the type of prioritization.

b. From the Class Value menu, specify the CoS class value to be reassigned for

packets that the voice VLAN receives.

You can select a value in the range from 0 to 6.

In the Protocol Based Global Settings section, specify the Auto VoIP settings for the
interfaces, which is described in the following steps.

7. Select whether to display physical interfaces, LAGs, or both by clicking one of the

following links above the table heading:

1 or Unit ID for a stacked switch:

Main User Manual

259

Configure Switching Information

Fully Managed Switches M4350 Series Main User Manual