NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 532)

- 1: If no switch stack is configured, the physical interfaces for the switch are
displayed.
- Unit ID for a stacked switch: If a switch stack is configured, the physical
interfaces for the switch with the selected stack unit ID are displayed.
• VLANS: Only VLANs are displayed.
• All: Both physical interfaces and VLANs are displayed, or for a switch stack, both
physical interfaces on all switches and VLANs are displayed.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the interface,
or type the interface number in the Go To Interface field and click the Go button.
• To configure multiple interfaces with the same settings, select the check box
associated with each interface.
• To configure all interfaces with the same settings, select the check box in the
heading row.
8. From the Admin Mode menu, select Enable or Disable to enable or disable IGMP
for the interface.
The default is Disable.
9. In the Version field, specify the version of IGMP for the interface.
The version can be 1, 2, or 3. The default is 3. This field is configurable only when
IGMP Interface mode is enabled.
10. In the Robustness field, enter the robustness value for the interface.
The robustness value allows tuning to compensate for the expected packet loss on
a subnet. IGMP is robust to (robustness value - 1) packet losses. If you expect the
subnet to be lossy, enter a higher number. The value is from 1 to 255. The default
is 2.
11. In the Query Interval field, enter the frequency in seconds at which IGMP host
membership query packets are transmitted on the interface.
The value is from 1 to 3600. The default is 125.
12. In the Query Max Response Time field, enter the maximum query response time,
in tenths of a second, for a Membership Report to be received before the IGMPv2
query expires on the interface.
The value is from 0 to 255. The default is 100.
13. In the Startup Query Interval field, enter the number of seconds between the
transmission of startup queries on the interface.
The value is from 1 to 300. The default is 31.
14. In the Startup Query Count field, enter the number of queries to be sent on startup,
with the time between queries determined by the startup query interval.
Main User Manual 532 Configure Multicast Routing
Fully Managed Switches M4350 Series Main User Manual