Configure a multicast interface – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 521
The following table describes the view-only fields on the page.
Table 124. Multicast global configuration information
Description
Field
The operational state of multicast forwarding.
Protocol State
The maximum number of entries in the Mroute table.
Table Maximum Entry Count
The multicast routing protocol that is active on the switch, if any
protocol is active.
Protocol
The number of multicast route entries present in the Mroute table.
Table Entry Count
Configure a multicast interface
You can configure one or more multicast interfaces.
To configure a multicast interface:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > Multicast > Interface Configuration.
The Interface Configuration page displays.
6. Select whether to display physical interfaces, VLANs, or both by clicking one of the
following links above the table heading:
•
1 or Unit ID for a stacked switch:
Main User Manual
521
Configure Multicast Routing
Fully Managed Switches M4350 Series Main User Manual