beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 270

background image

6. Select the Admin Mode Disable or Enable radio button.

This specifies whether the Auto-WiFi capability is enabled on the switch. By default,
the Auto-WiFi capability is disabled.

7. In the VLAN ID field, type the ID of the VLAN that must function as the Auto-WiFi

VLAN.

8. From the Priority menu, select the priority for traffic on the Auto-WiFi VLAN.

You can select a value from 0 to 7. The default value is 7.

9. Click the Apply button.

Your settings are saved.

The page displays the number of devices (WiFi channels) that are active on the
Auto-WiFi VLAN.

Configure an interface as member of the
Auto-WiFi VLAN

You can configure an interface as member of the Auto-WiFi VLAN.

To configure an interface as member of the Auto-WiFi VLAN:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Log in to the main UI with a web
browser
on page 27 and the subsections.

The login page displays.

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Switching > Auto-VLAN > Auto-WiFi > Interface Configuration.

The Auto-WiFi Interface Configuration page displays.

6. Select whether to display physical interfaces, LAGs, or both by clicking one of the

following links above the table heading:

1 or Unit ID for a stacked switch:

Main User Manual

270

Configure Switching Information

Fully Managed Switches M4350 Series Main User Manual