NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 569)

If you select Enable and conflict occurs, a static RP overrides an RP that is learned
from a BSR.
11. Do one of the following:
• If you are adding a new static RP, click the Add button.
Your settings are saved. The static RP is added.
• If you are changing an existing static RP, click the Apply button.
Your settings are saved.
12. To save the settings to the running configuration, click the Save icon.
Delete a static IPv6 PIM rendezvous point
configuration
You can delete a static IPv6 PIM rendezvous point (RP) configuration that you no longer
need for a group.
To delete a static IPv6 PIM RP configuration for a group:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > IPv6 Multicast > IPv6 PIM > Static RP Configuration.
The Static RP Configuration page displays.
6. Select the check box for the static RP.
7. Click the Delete button.
Your settings are saved. The static RP configuration is deleted for the group.
8. To save the settings to the running configuration, click the Save icon.
Main User Manual 569 Configure Multicast Routing
Fully Managed Switches M4350 Series Main User Manual