NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 285
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Switching > STP > Advanced > CST Port Configuration.
The CST Port Configuration page displays.
6. Select whether to display physical interfaces, LAGs, or both by clicking one of the
following links above the table heading:
•
1 or Unit ID for a stacked switch:
-
1: If no switch stack is configured, the physical interfaces for the switch are
displayed.
-
Unit ID for a stacked switch: If a switch stack is configured, the physical
interfaces for the switch with the selected stack unit ID are displayed.
•
LAG: Only LAGs are displayed.
•
All: Both physical interfaces and LAGs are displayed, or for a switch stack, both
physical interfaces on all switches in the stack and LAGs are displayed.
7. Select one or more interfaces by taking one of the following actions:
•
To configure a single interface, select the check box associated with the port, or
type the port number in the Go To Interface field and click the Go button.
•
To configure multiple interfaces with the same settings, select the check box
associated with each interface.
•
To configure all interfaces with the same settings, select the check box in the
heading row.
8. In the Port Priority field, specify the priority for the port in the CST.
Specify the port priority in multiples of 16. For example, if you set the port priority
to a value between 0 and 15, it is automatically set to 0. if you set the port priority to
a value between 16 and (2*16-1), it is automatically set to 16, and so on. The default
is 128.
9. From the Admin Edge Port menu, select Enable or Disable to specify if the port
functions as an edge port in the CIST.
The default is Disable.
10. In the Port Path Cost field, specify a path cost value for the port in the CIST
The value can be in the range from 1 to 200000000. The default is 0.
Main User Manual
285
Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual