beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 427

background image

Exclude ports from the VLAN.

Enable routing on the VLAN and specify an IP address and subnet mask for routing.

To create a routing VLAN with the VLAN static routing wizard:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Log in to the main UI with a web
browser
on page 27 and the subsections.

The login page displays.

3. Click the Main UI Login button.

The main UI login page displays in a new tab.

4. Enter admin as the user name, enter your local device password, and click the Login

button.

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.

The System Information page displays.

5. Select Routing > VLAN > VLAN Static Routing Wizard.

The VLAN Static Routing Wizard page displays.

The ports for the switch (Unit 1) are displayed. If a stack is configured, the ports for
each stacked switch (Unit 1, Unit 2, and so on) are displayed. In addition, all LAGs
are displayed, whether or not a stack is configured.

6. In the VLAN ID field, specify the VLAN identifier (VID) that must be associated with

the VLAN.

The range is from 1 to 4093.

7. In the IP Address field, specify the IPv4 address for the VLAN routing interface.

8. In the Network Mask field, specify the subnet mask for the VLAN routing interface.

9. In the Ports table (or if a stack is configured, in one of the Ports tables), click a port

once, twice, or three times to configure one of the following modes:

T (tagged) member: The port is added as a tagged member of the VLAN.

U (untagged) member: The port is added as an untagged member of the VLAN.

Excluded member: By default, the selection is blank, which means that the port
is excluded from the VLAN. A port that is excluded can still be dynamically added
to the VLAN through GVRP.

If a stack is configured, you can select ports in multiple tables.

10. In the LAG table, click a LAG once, twice, or three times to configure one of the

following modes:

Main User Manual

427

Manage Routing

Fully Managed Switches M4350 Series Main User Manual