NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 748)

Enable DHCPv6 snooping for the switch
You can globally enable DHCPv6 snooping for the switch.
To globally enable DHCPv6 snooping for the switch:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Security > Control > DHCPv6 Snooping > Global Configuration.
The Global Configuration page displays.
6. Select the DHCPv6 Snooping Mode Enable radio button.
The default is Disable.
7. To enable the verification of the sender’s MAC address for DHCPv6 snooping, leave
the MAC Address Validation Enable radio button selected.
The default is Enable.
When MAC address validation is enabled, the device checks packets that are received
on an untrusted interface to verify that the MAC address and the DHCPv6 client
hardware address match. If the addresses do not match, the device drops the packet.
8. Click the Apply button.
Your settings are saved.
9. To save the settings to the running configuration, click the Save icon.
Enable DHCPv6 snooping for a VLAN
To enable DHCPv6 snooping for a VLAN:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
Main User Manual 748 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual