NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 802)

To configure MAC binding:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Security > ACL > Basic > MAC Binding Configuration.
The MAC Binding Configuration page displays.
6. From the ACL ID menu, select an ACL.
7. From the Direction menu, select the traffic direction for the MAC binding:
• Inbound: The MAC binding can be applied to incoming traffic only.
• Outbound: The MAC binding can be applied to outgoing traffic only.
8. In the Sequence Number field, optionally specify a number to indicate the order of
the access list relative to other access lists already assigned to the interface and
direction.
A low number indicates high precedence order. If a sequence number is already in
use for the interface and direction, the specified access list replaces the currently
attached access list using that sequence number. If you do not specify the sequence
number, a sequence number that is one number greater than the highest sequence
number currently in use for the interface and direction is used. The range is from 1
to 4294967295.
9. To add the selected ACL to a port or LAG, in the Ports table (or if a stack is
configured, in one of the Ports tables) or LAG table, click the port or LAG so that a
check mark displays.
The Ports and LAG tables display the available interfaces for ACL bindings. You can
add the ACL to several ports and LAGs.
The ports for the switch (Unit 1) are displayed. If a stack is configured, the ports for
each stacked switch (Unit 1, Unit 2, and so on) are displayed. In addition, all LAGs
are displayed, whether or not a stack is configured.
10. Click the Apply button.
Main User Manual 802 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual