NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 846)

Table 183. EAP Statistics information (Continued)
Description Field
The protocol version number carried in the most recently received EAPOL
frame. EAPOL Last Frame Version
The source MAC address carried in the most recently received EAPOL frame. EAPOL Last Frame Source
The number of EAPOL frames that were received by this authenticator in which
the frame type is not recognized. EAPOL Invalid Frames
Received
The number of EAPOL frames that were received by this authenticator in which
the frame type is not recognized. EAPOL Length Error Frames
Received
The number of EAP response/identity frames that were received by this
authenticator. EAP Response/ID Frames
Received
The number of valid EAP response frames (other than resp/ID frames) that
were received by this authenticator. EAP Response Frames
Received
The number of EAP request/identity frames that were transmitted by this
authenticator. EAP Request/ID Frames
Transmitted
The number of EAP request frames (other than request/identity frames) that
were transmitted by this authenticator. EAP Request Frames
Transmitted
Perform a cable test
You can test and display information about the cables that are connected to switch
ports.
To perform a cable test:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
Main User Manual 846 Monitor the Switch and Network
Fully Managed Switches M4350 Series Main User Manual