Add a rule for an extended ipv4 acl – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual
Page 812
NOTE: An implicit deny all rule is included at the end of an ACL list. This means
that if an ACL is applied to a packet and if none of the explicit rules match,
then the final implicit deny all rule applies and the packet is dropped.
Add a rule for an extended IPv4 ACL
You can add a rule for an extended IPv4 ACL.
To add a rule for an extended IPv4 ACL:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Security > ACL > Advanced > IP Extended Rules.
If no rules exists, the Extended ACL Rule Table shows the message
No rules have
been configured for this ACL
. If one or more rule exists for the ACL, the rules display
in the Extended ACL Rule Table.
6. From the ACL ID/Name menu, select the IP ACL for which you want to add a rule.
For extended IP ACLs, this must be an ID in the range from 101 to 199 or a name.
7. Click the Add button.
Main User Manual
812
Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual