NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 368)

If the interface does not receive valid responses to PDELAY_REQ messages above
the value of the allowed lost responses, a port is considered to not be exchanging
peer delay messages with its neighbor. The range is from 0 to 65,535. The default
is 3.
11. In the Initial Sync Interval field, specify the transmission rate of SYNC messages.
This value is the logarithm to the base 2 of the mean-time interval between successive
SYNC messages sent on this interface. The configured initial interval becomes the
current interval only after the port is initialized or re-initialized for 802.1AS operation.
The range is from –5 to 5. The default is –3.
12. In the Initial Pdelay Interval field, specify the transmission rate of PDELAY_REQ
messages.
This value is the logarithm to the base 2 of the mean time interval between successive
PDELAY_REQ messages sent on this interface. The configured initial interval becomes
the current interval only after the port is initialized or re-initialized for 802.1AS
operation. The range is from –5 to 5. The default is –3.
13. In the Initial Announce Interval field, specify the transmission rate of ANNOUNCE
messages.
This value is the logarithm to the base 2 of the mean time interval between successive
ANNOUNCE messages sent on this interface. The configured initial interval becomes
the current interval only after the port is initialized or re-initialized for 802.1AS
operation. The range is from –5 to 5. The default is –3.
14. In the SyncRx Timeout field, specify the number of SYNC intervals.
This value sets the number of SYNC intervals that must pass without receipt of SYNC
information before the switch detects that the master clock is no longer transmitting.
15. n the AnnounceRx Timeout field, specify the number of ANNOUNCE intervals.
This value sets the number of ANNOUNCE intervals that must to pass without receipt
of ANNOUNCE PDU before the switch detects that the master clock is no longer
transmitting.
16. Click the Apply button.
Your settings are saved.
17. To save the settings to the running configuration, click the Save icon.
The following table describes the view-only fields on the page.
Main User Manual 368 Configure Switching Information
Fully Managed Switches M4350 Series Main User Manual