NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 104)

The System Information page displays.
5. Select System > Management > Time > Daylight Saving Configuration.
The Daylight Saving Configuration page displays.
6. To refresh the page, click the Refresh button.
The following table displays the view-only daylight saving (DST) status information.
Table 23. Daylight saving status information
Description Field
The Daylight Saving value, which is one of the following:
• Disable
• Recurring
• Recurring EU
• Recurring USA
• Non Recurring
Daylight Saving (DST)
Displays when the daylight saving time begins. This field is not displayed
when daylight saving time is disabled. Begins At
Displays when the daylight saving time ends. This field is not displayed when
daylight saving time is disabled. Ends At
The offset value in minutes.This field is not displayed when daylight saving
time is disabled. Offset (in Minutes)
The zone acronym. This field is not displayed when daylight saving time is
disabled. Zone
Displays whether daylight saving time is in effect. Daylight Saving (DST) in Effect
Precision Time Protocol
Precision Time Protocol (PTP, IEEE 1588) is a protocol that enables precise
synchronization of clocks with a sub-microsecond accuracy across a packet-based
network. PTP lets network devices of different precision and resolution synchronize to
a grandmaster clock through an exchange of packets across the network. The switch
supports a PTP end-to-end transparent clock, which is enabled by default, both globally
and at the port level.
NOTE: The switch itself is not affected by PTP.
Main User Manual 104 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual