NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 437)

The RIP Configuration page displays.
6. Select the RIP Admin Mode Enable or Disable radio button to enable or disable RIP
on the switch.
The default is Enable.
7. Click the Apply button.
Your settings are saved.
8. To save the settings to the running configuration, click the Save icon.
Configure the global RIP settings for the
switch
You can configure the global RIP settings for the switch, as opposed to the RIP settings
for individual interfaces.
To configure global RIP settings for the switch:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > RIP > Advanced > RIP Configuration.
The RIP Configuration page displays.
6. Select the RIP Admin Mode Enable or Disable radio button to enable or disable RIP
on the switch.
The default is Enable.
7. Select one of the following Split Horizon Mode radio buttons:
Main User Manual 437 Manage Routing
Fully Managed Switches M4350 Series Main User Manual