NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 804)

a. Select the check box next to the interface.
b. Click the Delete button.
The binding is removed.
7. To save the settings to the running configuration, click the Save icon.
The following table describes the information that is displayed in the MAC binding
table.
Table 177. MAC Binding Table information
Description Field
The interface to which the ACL is bound. Interface
The selected packet filtering direction for the ACL. Direction
The type of ACL assigned to selected interface and direction. ACL Type
The ACL name identifying the ACL assigned to selected interface and direction. ACL ID
The sequence number signifying the order of the specified ACL relative to other ACLs
assigned to selected interface and direction. Sequence Number
Configure a basic or extended IPv4 ACL
An IPv4 ACL consists of a set of rules that are matched sequentially against a packet.
When a packet meets the match criteria of a rule, the specified rule action (Permit or
Deny) is taken, and the additional rules are not checked for a match. You must specify
the interfaces to which an IPv4 ACL applies, as well as whether it applies to inbound or
outbound traffic.
Multiple steps are involved in defining an IPv4 ACL and applying it to the switch:
1. Add an IPv4 ACL ID (see Add an IPv4 ACL on page 805).
The differences between a basic IPv4 ACL and an extended IPv4 ACL are as follows:
• Numbered ACL from 1 to 99: Creates a basic IPv4 ACL, which allows you to
permit or deny traffic from a source IP address.
• Numbered ACL from 100 to 199: Creates an extended IPv4 ACL, which allows
you to permit or deny specific types of Layer 3 or Layer 4 traffic from a source IP
Main User Manual 804 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual