NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 627)

User accounts and passwords
You can configure user accounts and login passwords. By default, two user accounts
exist:
• admin, with read and write (read/write) privileges
• guest, with read-only privileges
The account names are not case-sensitive.
The first time that you log in as an admin user to the main UI, no password is required
(that is, the password is blank). After you log in for the first time, you are required to
specify a local device password that you then must use to log in again. Each subsequent
time that you log in, you must use your local device password.
A guest user cannot log in until the admin user specifies a password for the guest user.
If you log in as an admin user with read/write privileges, you can assign passwords, set
security parameters for the default accounts, and add and delete accounts (other than
the admin account), up to a maximum of six accounts. As an admin user with read/write
privileges, you modify all data on the main UI pages.
Add or change a user account
You can add or change a user account, including the predefined users accounts admin
and guest .
To add or change a user account:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Security > Management Security > Local User > User Management.
Main User Manual 627 Manage Switch Security
Fully Managed Switches M4350 Series Main User Manual