beautypg.com

Configure isdp settings for an interface – NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 223

background image

6. Select the Admin mode Disable or Enable radio button to specify is the ISDP service

is disable or enabled.

The default is Enabled.

7. In the Timer field, specify the period in seconds between the transmission of ISDP

packets.

The range is from 5 to 254 seconds. The default is 30 seconds.

8. In the Hold Time field, specify the hold time for ISDP packets that the switch transmits.

The hold time specifies how long a receiving device must store information sent in
the ISDP packet before discarding it. The range from 10 to 255 seconds. The default
is 180 seconds.

9. Select the Version 2 Advertisements Disable or Enable radio button to specify if the

switch can send ISDPv2 packets.

The default is Enabled.

10. Click the Apply button.

Your settings are saved.

11. To save the settings to the running configuration, click the Save icon.

The following table describes the view-only fields on the page.

Table 56. ISDP global configuration information

Description

Field

The time that the information in the neighbors table was changed.

Neighbors table last time
changed

The device ID of this switch.

Device ID

The device ID format capability.

Device ID Format Capability

The device ID format.

Device ID Format

Configure ISDP settings for an interface

You can configure if an interface can communicate IDSP packets.

To configure ISDP settings for an interface:

1. Launch a web browser.

2. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Log in to the main UI with a web
browser
on page 27 and the subsections.

The login page displays.

Main User Manual

223

Configure Switch System
Information

Fully Managed Switches M4350 Series Main User Manual