NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 964)

Table 195. Security features default settings (Continued)
Default Feature Name/Setting
Control, Captive Portal, CP Group
1 Group ID
Default Group name
Control, Captive Portal, CP Trap Flags
Disabled CP Trap mode
None Client authentication failure
Disabled Client connect
None Client DB full
Disabled Client disconnect
ACL
No default ACLs configured
100. This total number applies to all MAC ACLs,
IPv4 ACLs, and IPv6 ACLs together. Total number of supported ACLs
None configured MAC ACLs
None configured IP ACLs
None configured IPv6 ACLs
Monitoring features default settings
The following table describes the default settings for the monitoring features that you
can configure.
(View-only settings are not included in the table but might be included in the data sheet,
which you can download by visiting netgear.com/support/download/.)
Table 196. Monitoring features default settings
Default Feature
Logs, Memory Log
Enabled Admin status
Wrap Behavior
Notice Severity filter
Main User Manual 964 Software Default Settings and
Hardware Specifications
Fully Managed Switches M4350 Series Main User Manual