NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 549)

The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > Multicast > PIM > Candidate RP Configuration.
The Candidate RP Configuration page displays.
6. From the Interface menu, select the interface.
7. Select the check box for the PIM candidate RP.
8. Click the Delete button.
Your settings are saved. The PIM candidate RP entry is removed.
Configure an interface as an IPv4 PIM
bootstrap router candidate
You can configure an interface as an IPv4 PIM bootstrap router (BSR) candidate.
To configure an interface as an IPv4 PIM BSR candidate:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > Multicast > PIM > BSR Candidate Configuration.
The BSR Candidate Configuration page displays.
6. From the Interface menu, select an interface.
7. In the Hash Mask Length field, specify the hash mask length to be advertised in
bootstrap messages.
The hash mask length is used in the hash algorithm for selecting the RP for a particular
group. The range is from 0 to 32. The default is 30.
Main User Manual 549 Configure Multicast Routing
Fully Managed Switches M4350 Series Main User Manual