beautypg.com

NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch User Manual

Page 502

background image

Your settings are saved.

20. To save the settings to the running configuration, click the Save icon.

The following table describes the view-only fields on the page.

Description

Field

The IP address of the interface

IPv6 Address

The number of seconds that the interface must wait before sending a delayed
acknowledgement.

LSA Ack Interval

State

The state of the OSPFv3 interface:

Down: This is the initial interface state. The interface is not usable for OSPFv3, and the interface settings are
at their initial values. All interface timers are disabled, and no adjacencies are associated with the interface.

Loopback: The interface is looped back either in hardware or software. The interface is unavailable for regular
data traffic. You can get information about the interface by sending ICMP pings to the interface or through a
bit error test because IP packets can still be addressed to an interface in a loopback state. An interface in a
loopback state is advertised in LSAs as single host route for which the destination is the IP interface address.

Waiting: The switch is monitoring received hello packets to detect the identity of the backup designated router
for the network. The switch cannot elect a backup designated router or a designated router until it transitions
out of the waiting state. This prevents unnecessary changes of the backup designated router.

Designated Router: The switch is the designated router on the attached network. Adjacencies are established
to all other routers and switches that in the network. The switch must also originate a network LSA for the
network node. The network LSA contains links to all switches and routers (including the designated router) in
the network.

Backup Designated Router: The switch is the backup designated router on the attached network. The switch
is promoted to designated router if the current designated router fails. The switch establishes adjacencies to
all other routers attached to the network. The backup designated router performs slightly different functions
during the LSA flooding, as compared to the designated router.

Other Designated Router: The interface is connected to a broadcast on which other routers are the designated
router and backup designated router. The switch attempts to form adjacencies to both the designated router
and the backup designated router.

The identity of the designated router for this network, as detected by the advertising
router. The designated router is identified by its router ID. The value 0.0.0.0 means
that no designated router is detected.

Designated Router

The identity of the backup designated router for this network, as detected by the
advertising router. The backup designated router is identified by its router ID. The
value 0.0.0.0 means that no backup designated router is detected.

Backup Designated
Router

The number of times the OSPFv3 interface changed its state.

Number of Link Events

Main User Manual

502

Configure OSPF and OSPFv3

Fully Managed Switches M4350 Series Main User Manual