NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 178)

Table 46. PoE information
Description Field
Displays whether N+1 is enabled (Yes or No) N+1 Active
The number of connected and active APSs Number of PSU
The number of connected and active APSs while the N+1 mode is enabled Effective Number of PSU
Display information about multiple power
source management for PoE power
The default PoE power that a switch can deliver depends on the internal power supply.
The
maximum PoE power that a single switch can deliver depends on the number and
types of optional auxiliary power supplies (APSs) that are installed in the switch.
For example, model M4350-48G4XF comes with one internal power supply unit (PSU)
and provides two power supply bays that can accommodate different types of APSs
(350W, 600W, 920W, or 2000W).
The multi-power source management (MPSM) table displays the available power for
PoE operations for seven possible combinations out of these three power supplies (one
internal power supply and two APSs).
To display information about multiple power source management:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > PoE > Advanced > Power Configuration.
The Power Configuration page displays.
Main User Manual 178 Configure Switch System
Information
Fully Managed Switches M4350 Series Main User Manual