NETGEAR M4350-24F4V 24-Port 10G SFP+ Managed AV Network Switch - Manual (Page 554)

The Static Routes Configuration page displays.
6. If you are changing an existing static multicast route, select the check box for the
route.
For an existing static route, you can change the metric only.
7. In the Source IP field, specify the IPv4 address of the multicast packet source.
8. In the Source Mask field, specify the subnet mask of the multicast packet source.
9. In RPF Neighbor field, specify the IPv4 address of the neighbor RPF router that is
located between the switch and the multicast source.
10. In the Metric field, specify the link state cost of the path from the multicast source
to the switch.
The range is from 0 to 255.
11. Do one of the following:
• If you are adding a new static multicast route, click the Add button.
Your settings are saved. The static multicast route is added.
• If you are changing an existing static multicast route, click the Apply button.
Your settings are saved.
12. To save the settings to the running configuration, click the Save icon.
Delete a static multicast route for an IPv4
address
You can delete a static IPV4 multicast route that you no longer need.
To delete a static IPv4 multicast route:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Log in to the main UI with a web
browser on page 27 and the subsections.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
Main User Manual 554 Configure Multicast Routing
Fully Managed Switches M4350 Series Main User Manual